Event
Help Needed: Jitter Issue in DIY 6-DOF Motion Control Camera
1 reports · 1 sources
A freelance filmmaker's DIY 6-DOF motion control camera uses Robstride actuators running in MIT mode on an STM32 and currently exhibits noticeable vibration and jitter during loaded coordinated motion of the J2/J3 joints. The author has tried implementing a cogging torque compensation table and a gravity model but has not resolved the jitter; the arm is usable in stop-motion photography scenarios, but motion smoothness still falls short of requirements, and the author is seeking advice from the community.
Report timeline
- Help sought with actuator jitter on 6-DOF motion-control camera
A freelance filmmaker's DIY 6-DOF motion-control camera uses Robstride actuators running in MIT mode on an STM32, and now shows noticeable vibration and jitter when the J2/J3 joints move together under load. The author has tried implementing a cogging-torque compensation table and a gravity model but has not resolved the jitter; the arm is usable for stop-motion scenarios, but motion smoothness still falls short of requirements, and the author is asking the community for suggestions.
Reddit r/robotics ·